Russound Collage Manual de Instalação descarregar pdf (Página 16)

16 Russound Collage System Installation Manual

Install back box

Install the back box in the hole and secure using the included hardware. This 1.

includes the two doglegs that are adjusted to snug the back box up against

the inside of the wall (Do not use a cordless drill; tighten by hand only). The

doglegs have a minimum clamping distance of 3/8" (9.5 mm) and a maximum

distance of 7/8" (22 mm). The large power pocket opening should be on the

bottom of the box. If using metal clad wire, the box will have to be installed

upside down to accommodate the bend radius of this type of wire (e.g., BX).

Pull/Connect the wire

Pull the electrical feed from the light switch or electrical outlet through the 2.

back box. Install the strain relief into the power pocket.

Secure the electrical wire to the uninstalled power pocket by passing it

through the strain relief (for use with non-metallic cable such as Romex®). If

using metallic cable, you will need to provide the correct strain relief for this

cable. The knockout is for a standard 3/8" (9.5 mm) strain relief.

Connect the electrical wire to the ying leads from the power supply and to

the ying ground lead on the power pocket. Do not remove the metal choke

from the ying leads of the power supply.

Power pocket assembly

Once the electrical wire has been connected, slide the power supply into the 5.

power pocket. Manipulate the wires into the wire management side of the

power pocket. Feed the power supply lead and the communication cable

through the holes on the trade separator plate. Fit the plate snugly in place

on top of the power supply and snap shut.

The CAT-5 communication cable and the power supply lead should be visible

and unobstructed at the top of the power pocket. Slide the power pocket

through the back box opening and snug it into place.

Line up the hole in the back box with the hole in the power pocket lip. Remove

the plastic pin from the expandable grommet and install the grommet in the

holes. Replace the pin in the grommet to secure the power pocket to the back

box.

INSTALLATION  BACK BOX

Connections and assembly of keypad parts

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

Russound Collage Manual de Instalação Página 16