Russound ST2-XM Manual do Utilizador descarregar pdf (Página 6)

6 of 9

SMS3

STREAM SOURCES

If you have a SMS3 that you wish to control via ACA-E5/ZXP-E5 keypads, you must wire both of the

following:

 RNet cables between the ACA-E5 and SMS3

 Ethernet Cables from the SMS3 and the ACA-E5 to the same Switch/Router

During SCS-E5 programming, assign each output (Stream) of the SMS3 to a Source Input on the ACA-

E5. For control via RNet, the SMS3 and ACA-E5 must both be connected to the same network as well as

via RNet cabling.

During SMS3 programming, set each stream to the correct RNet ID. The RNet ID should correspond to

the correct source input numbers on the ACA-E5.

See the SMS3 Integration Note or Russound documentation for full details.

Note: ELAN will control the SMS3 through Ethernet, regardless of its inclusion into your RNet device

network.

IBRIDGE

The iBridge will need to be configured and working with Russound keypads prior to integration with

ELAN. Note the ID rotary dial on the rear of the iBridge must be configured to the source number being

used on the Sphere zone controller.

Note that iBridge may be directly connected via RNET to certain sources on the ACA-E5, or it may

require an adapter module—see Russound documentation for details.

ELAN Configuration Details:

1. Add a Russound RNET Peripheral Device under Media: Keypad Controllers.

 The iBridge should use the same Communication Device as the Sphere zone controller.

 Assign the correct RNET ID to the RNET Peripheral Device.

2. Add a Keypad Interface for the iBridge.

 Right-Click on Keypad Interfaces and Add New. Name as desired.

 Choose Template: Russound iBridge

 Connect to: <ACTIVE ZONE HANDLER>

3. Modify each resolution of the keypad interface to display correct current track information.

1 2 3 4 5 6 7 8 9

Sem comentários

Russound ST2-XM Manual do Utilizador Página 6